Product Specification
Brand
Techgenix Solution
Part Number
XH-M131
Material
Steel, Plastic, PVC
Model Name/Number
XH-M131 DC 12V Light Control Switch Photoresistor Relay Module
Trigger Voltage (VDC)
12
Switching Voltage (VAC)
250@10A
Switching Voltage (VDC)
30@10A
Operating Current
Before the relay actuation: less than 5mA ; Relay after pull-in: 5V module is less than 50mA
LDR Probe Length(mm)
300
Relay working mode
NO(normally open) or NC(normal closed)
Product DescriptionBuy the new XH-M131 DC 12V Light Control Switch Photoresistor Relay Module. The Light Detection and brightness detection, detection can be adjusted via potentiometer brightness valve point comes relays, and do all kinds of brightness detection switch, you can control all kinds of street lights automatically turn on at night, during the day and automatically turns off and car supplies control and automation equipment. Using the photoresistor induction light intensity comes with the relay and direct control load. It has a Distribution bit sensitivity adjustment. The start relay threshold is set by adjusting the potentiometer. 12 V power input is designed for relay board regulator transistors to provide sensors and is Used to make the product more stable and reliable. It has four fixed bolt hole for easy installation. Features:
XH-M131 DC 5V / DC 12V Light Control Switch Photoresistor Relay Module Light threshold can be adjusted by a potentiometer to set the relay start Input: DC5V / 12V
Load capacity: 10A / AC 250V or DC up to 30V RED LED ON: Indicate the Power ON
BLUE LED ON: Relay is working Module output terminal has three ports.
Weight: approx 20 g Material: Steel, Plastic, PVC
Effective VCC, GND power input, can relay a separate power supply relay power input of JD-VCC
Input IN1, IN2, IN3, IN4 signal line active low
5V 4-Channel relay board controlled directly by micro-controller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic) need 50-60mA driver current