₹ 380/Kg
- Usage/Application: Industrial
- Physical State: Liquid
- Packaging Size: 100 ml
Product Description:
They are known as white ants, live in colonies with assembly of millions. They also damage building constructions entering from ground level to upper level through joints gaps in floors, wall cavities, intersperse of bricks and wood work. The damages caused by termites are likely to be 35% to 40%. How To Protect In highly infested areas, the building can be seriously effected within a short span of construction. The effective and novel approach to provide complete protection is at the time of planning and construction of building. The best way to control termites is to establish chemical barrier between termites and the assets. The only alternative is to select and use the quality product Terminator in order to control / minimize / kill the termites. Salient Features Triple Action Formula :Contact, Stomach And Fumigation Highly Effective Longer Residual Control. Broad Spectrum Control. High Speed Of Killing Low Toxicity To Non-target Species No Leaching Maximum Absorbing Capacities. Cost Effective. RECOMMENDED DOSES Mix 1 litre Terminator with 19 litre of water to make 1% a.i. emulsion and to be applied in following stage. Pre Construction Treatment (For New Structure) Stage 1. (During foundation Preparation) Apply the emulsion on the bottom surface and sides of foundation pits to the height of 30 c.m. @ 5 litre/sq. mtr. of surface area. Stage 2. (After Completion of foundation). On both sides of all built up walls, treat the refill earth (approx. width 30 cm depth 45 cm) @ 7.5 litre per linear metre. Stage 3. (Before laying of floor). The entire leveled surface to be treated @ 5 litre per square meter. Stage 4. (After completion of building) Treat the earth along the external perimeter of the building @ 7.5 litre of spray per linear meter. Post Construction Treatment (For Existing Building) Make a complete inspection of termite infestation and route of entry into the building. After careful inspection of termites infested area, inject 1% of Terminator emulsion in the soil which is in contact with the external wall of the building, at the rate of 7.5 litre per sq. Meter upto a depth of 30 cm 15 cm apart. Inside the building, drill 12 mm holes at the junction of floor and wall, along the cracks on the floor, and along constructional joints at 30 cm intervals to reach the soil below. Squirt the emulsion @ 1 litre per hole or till refusal and seal the holes properly with the cement. Treatment of wood work: Mix 1 litre of Terminator in 19 litre of kerosin oil / terpentine oil and brush all the surface of timber. If termite infestation is there, drill 3 mm holes in existing wood work with a downward slant. Liberally infuse Terminator emulsion till refusal. Repeat the same application after drying. For new and replacement timber, dipping overnight in Terminator kerosin emulsion will ensure deep penetration and better protection against difficult to control wood boring insects such as powder post beetle, pin hole borers, furniture beetle etc. Terminator is also very commonly used in wood seasoning plants and handicraft industries. Forestr/Nursery Prepare 0.3% (active ingredient) emulsion of Terminator, mix with soil at the rate of 50 litre of emulsion per cubic meter of soil. for planting nursery plants, use rotary drum to mix the soil and emulsion properly. alternatively, drench the soil in polythene bags with the above emulsion at the rate of 1 litre of emulsion per 20 polythen bags of normal size (20 cm x 10 cm). For grown up trees, dig a trench of 25 cm radius and 15 cm deep around the base of a tree and apply the above 0.3 % emulsion @ 1 litre per tree.
