Overall Size: 660 mm x485 mm x1625 mm ht Tubular frame made from 25.4 x 25.4x 18 swg ERW Tube Five drawers with internal compartments at least 30 per drawer formed with partitions from 5mm thick soft board easily detachable, for first 4 drawers First two drawers 70 mm third and fourth drawer 100 mm and the fifth drawer at least 295 mm All drawers mounted on heavy duty telescopic channels 2 lines of flip out bins with transparent front to see the content inside with provision for labeling each line to be at least 600 mm l x 140 mm d 4 no s 100 mm non rusting revolving castors 2 with brake and 2 without brake Handle on the left to move the trolley Telescopic writing pad under the Stainless steel top, Top in S.S 1mm thick press bent on three sides with raised edges by at least 50 mm to act as railing Stainless file container on the right side of the trolley 2 waste carrying bins in plastics on the left side of the trolley Cylinder cage on the back side of the trolley which can slide below when not in use Telescopic IV attachment on left side of the trolley Monitor try on the top at least 150 mm deep Finish: All components should be pretreated in separate eight tank process for better finish, good adhesion and corrosion protection. Process includes Hot Degreasing, De rusting, Activation, Phosphating & Number of Water rinses as per IS 3618 - 1966 class C type The pretreated material is coated with epoxy polyester powder with film thickness of 60 microns (approx.) and then oven baked at 180 degree centigrade
