Panasonic PT-DW11K DLP Projector, 1366 × 768 pixel, for Classroom & Office Use

Screen Size

70 inch – 1000 inch

Display Type

DLP Chip × 3 (R, G, B), DLP Projection System

Model Number

PT-DW11K

Brand

Panasonic

Resolution

1366 × 768 pixel (Input Signals That Exceed This Resolution Will Be Converted To 1366 × 768 pixel.)

Power supply

120 V AC, 9.1 A, 50/60 Hz; 220–240 V AC, 4.8 A, 50/60 Hz

Power consumption - 120 V AC, 50/60 Hz

980 W (1,010 VA) (0.2 W with standby mode set to eco. 6 W with standby mode set to normal. Both with fan stopped.)

Power consumption - 220–240 V AC, 50/60 Hz

950 W (980 VA) (0.3 W with standby mode set to eco. 9 W with standby mode set to normal. Both with fan stopped.)

DLP chip - Panel size

21.6 mm (0.85 inches) diagonal (16:9 aspect ratio

DLP chip - Pixels

1,049,088 (1,366 × 768) × 3, total of 3,147,264 pixels

Lens

Optional powered zoom/focus lenses

Lamp

380 W UHM lamps (× 2) (dual lamp, high mode)

Brightness

11,000 lumens (dual lamp, high mode)

Center-to-corner uniformity

90%

Contrast

10,000:1 (full on/full off, in dynamic iris 3 mode)

Scanning frequency - HDMI/DVI-D/RGB

Horizontal: 15 kHz–100 kHz, vertical: 24 Hz – 120 Hz, dot clock: 25–162 MHz or lower (HDMI/DVI: 25 MHz – 162 MHz)

Scanning frequency - YPBPR (YCBCR)

525i (480i): fH 15.75 kHz; fV 60 Hz, 625i (576i): fH 15.63 kHz; fV 50 Hz, 525p (480p): fH 31.50 kHz; fV 60 Hz, 625p (576p): fH 31.25 kHz; fV 50 Hz, 750 (720)/60p: fH 45.00 kHz; fV 60 Hz, 750 (720)/50p: fH 37.50 kHz; fV 50 Hz, 1125 (1035)/60i: fH 33.75 kHz; fV 60 Hz, 1125 (1080)/60i: fH 33.75 kHz; fV 60 Hz, 1125 (1080)/50i: fH 28.13 kHz; fV 50 Hz, 1125 (1080)/25p: fH 28.13 kHz; fV 25 Hz, 1125 (1080)/24p: fH 27.00 kHz; fV 24 Hz, 1125 (1080)/24sF: fH 27.00 kHz; fV 48 Hz, 1125 (1080)/30p: fH 33.75 kHz; fV 30 Hz, 1125 (1080)/60p: fH 67.50 kHz; fV 60 Hz, 1125 (1080)/50p: fH 56.25 kHz; fV 50 Hz

Scanning frequency - Video/S-Video

fH: 15.75 kHz, fV: 60 Hz [NTSC/NTSC4.43/PAL-M/PAL60] fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM]

Optical axis shift - Vertical

±70% (±60% with the ET-D75LE6) from center of screen, powered

Optical axis shift - Horizontal

±30% (±20% with the ET-D75LE6) from center of screen, powered

Keystone correction range

Vertical ±40° (vertical ±22° with the ET-D75LE5/LE50, vertical ±28° with the ET-D75LE6)

Installation

Ceiling/floor, front/rear

Terminals - HDMI IN

HDMI 19-pin × 1, Deep Color, compatible with HDCP, 525i(480i), 625i(576i), 525p(480p), 625p(576p), 750(720)/60p, 750(720)50p, 1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p, 1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p, 1125(1080)/60p, 1125(1080)/50p, VGA (640 × 480) – WUXGA*4 (1,920 × 1,200), dot clock: 25 MHz –162 MHz

Terminals - DVI-D IN

DVI-D 24-pin × 1, DVI 1.0 compliant, HDCP compatible, for single link only 525i(480i), 625i(576i), 525p(480p), 625p(576p), 750(720)/60p, 750(720)50p, 1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p, 1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p, 1125(1080)/60p, 1125(1080)/50p VGA (640 × 480) – WUXGA (1,920 × 1,200), dot clock: 25 MHz –162 MHz

Terminals - RGB 1 IN

BNC × 5

Terminals - R, G, B

R: 0.7 Vp-p, 75 ohms, G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms, B: 0.7 Vp-p, 75 ohms HD, VD/SYNC: TTL, high impedance, positive/negative automatic

Terminals - Y, PB, PR (Y, CB, CR)

Y: 1.0 Vp-p (including sync signal), PB/PR (CB/CR): 0.7 Vp-p, 75 ohms

Terminals - S-Video signal

Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms

Terminals - RGB 2 IN

D-sub HD 15-pin (female) × 1

Terminals - VIDEO IN

BNC × 1, 1.0 Vp-p, 75 ohms

Terminals - 3D SYNC 1 IN/OUT

BNC × 1, 1.0 Vp-p, 75 ohms Input: TTL, high impedance. Output: TTL, max. 10 mA

Terminals - 3D SYNC 2 OUT

BNC × 1, 1.0 Vp-p, 75 ohms, TTL, max. 10 mA

Terminals - SERIAL IN

D-sub 9-pin (female) × 1 for external control (RS-232C compliant)

Terminals - SERIAL OUT

D-sub 9-pin (male) × 1 for link control (RS-232C compliant)

Terminals - REMOTE 1 IN

M3 jack × 1 for wired remote control

Terminals - REMOTE 1 OUT

M3 jack × 1 for link control

Terminals - REMOTE 2 IN

D-sub 9-pin × 1 for external control (parallel)

Terminals - LAN

RJ-45 × 1 for network connection, 100Base-TX/10Base-T, compliant with PJLink (class 1)

Power cord length

3.0 m (9 ft 10 in)

Cabinet materials

Molded plastic

Dimensions (W × H × D)

530 × 200 × 548.5 mm (20-7/8 × 7-7/8 × 21-19/32 inches) (without lens)

Weight

24 kg (52.9 lbs) (without lens)

Operation noise

45 dB (high mode), 43 dB (middle mode), 37 dB (eco mode)

Operating temperature

0°– 45°C (32°–113°F)

Operating humidity

10%–80% (no condensation)

Remote control unit - Power supply

3 V DC (AA/R6 type battery × 2)

Remote control unit - Operation range

Approx. 30 m (98 ft 5 in) when operated from directly in front of the signal receptor

Remote control unit - Dimensions (W × H × D)

51 × 176 × 28 mm (2 × 6-15/16 × 1-3/32 inches)

Remote control unit - Weight

Approx. 134 g (4.7 oz) (including batteries)

Supplied accessories

Power cord (×1) (x2 for PT-DW11KE) Wireless/wired remote control unit (× 1) Batteries for remote control (AA/R6 type × 2) Softwar Lens drop-prevention screw (× 1) e CD-ROM (Logo Transfer Software, Multi Projector Monitoring & Control Software) (× 1)

Optional accessories

Zoom lens (1.0 – 1.2:1) - ET-D75LE6, Zoom lens (1.4 – 1.9:1) - ET-D75LE10, Zoom lens (1.8 –2.7:1) - ET-D75LE20, Zoom lens (2.7 –5.2:1) - ET-D75LE30, Zoom lens (5.1 –8.2:1) - ET-D75LE40, Zoom lens (8.2 –15.4:1) - ET-D75LE8, Fixed-focus lens (0.8:1) - ET-D75LE50, Lens motor cover - ET-D75MC1, Ceiling mount bracket - ET-PKD120H (for high ceilings), ET-PKD120S (for low ceilings), Attachment for ceiling mount bracket - ET-PAD310, Frame - PFD310, Smoke cut filter - ET - SFD320, Replacement lamp unit - ET-LAD310A (one bulb) ET-LAD310AW (a set of two bulbs), Replacement lamp unit for portrait mode - ET-LAD320P (one bulb) ET-LAD320PW (a set of two bulbs), Replacement filter unit - ET-EMF320