Panasonic PT-DZ10K DLP Projector, 1920 × 1200 pixel, for Classroom & Office Use

Screen Size

70 inch – 1000 inch

Display Type

DLP Chip × 3 (R, G, B), DLP Projection System

Model Number

PT-DZ10K

Brand

Panasonic

Resolution

1920 × 1200 pixel

Power supply

120 V AC, 9 A, 50/60 Hz 220–240 V AC, 4.7 A, 50/60 Hz

Power consumption - 120 V AC, 50/60 Hz

925 W (1,010 VA) (0.2 W with standby mode set to eco. 6 W with standby mode set to normal. Both with fan stopped.)

Power consumption - 220–240 V AC, 50/60 Hz

900 W (980 VA) (0.3 W with standby mode set to eco. 9 W with standby mode set to normal. Both with fan stopped.)

DLP chip - Panel size

24.4 mm (0.96 inches) diagonal (16:10 aspect ratio)

DLP chip - Pixels

2,304,000 (1,920 × 1,200) × 3, total of 6,912,000 pixels

Lens

Optional powered zoom/focus lenses

Lamp

355 W UHM lamps (× 2) (dual lamp, normal mode)

Brightness

10,600 lumens (dual lamp, normal mode)

Center-to-corner uniformity

90%

Contrast

10,000:1 (full on/full off, in dynamic iris 3 mode)

Scanning frequency - SDI

3G-SDI signal (RGB 4:4:4 12-bit/10-bit): SMPTE ST 424 compliant: 1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p, 1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p 3G-SDI signal (YPBPR 4:2:2 10-bit): SMPTE ST 424 compliant: 1125(1080)/60p, 1125(1080)/50p HD-SDI signal (YPBPR 4:2:2 10-bit): SMPTE ST 292 compliant: 750(720)/60p, 750(720)/50p, 1125(1035)/60i, 1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p, 1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p SD-SDI signal (YCBCR 4:2:2 10-bit): SMPTE ST 259 compliant: 525i(480i), 625i(576i)

Scanning frequency - HDMI/DVI-D/RGB

Horizontal: 15 kHz–100 kHz, vertical: 24 Hz – 120 Hz, dot clock: 25 –162 MHz or lower (HDMI/DVI: 25 MHz – 162 MHz)

Scanning frequency - YPBPR (YCBCR)

525i (480i): fH 15.75 kHz; fV 60 Hz, 625i (576i): fH 15.63 kHz; fV 50 Hz, 525p (480p): fH 31.50 kHz; fV 60 Hz, 625p (576p): fH 31.25 kHz; fV 50 Hz, 750 (720)/60p: fH 45.00 kHz; fV 60 Hz, 750 (720)/50p: fH 37.50 kHz; fV 50 Hz, 1125 (1035)/60i: fH 33.75 kHz; fV 60 Hz, 1125 (1080)/60i: fH 33.75 kHz; fV 60 Hz, 1125 (1080)/50i: fH 28.13 kHz; fV 50 Hz, 1125 (1080)/25p: fH 28.13 kHz; fV 25 Hz, 1125 (1080)/24p: fH 27.00 kHz; fV 24 Hz, 1125 (1080)/24sF: fH 27.00 kHz; fV 48 Hz, 1125 (1080)/30p: fH 33.75 kHz; fV 30 Hz, 1125 (1080)/60p: fH 67.50 kHz; fV 60 Hz, 1125 (1080)/50p: fH 56.25 kHz; fV 50 Hz

Scanning frequency - Video/S-Video

fH: 15.75 kHz, fV: 60 Hz [NTSC/NTSC4.43/PAL-M/PAL60] fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM]

Optical axis shift - Vertical

±55% (±44% with the ET-D75LE6) from center of screen, powered

Optical axis shift - Horizontal

±20% (±15% with the ET-D75LE6) from center of screen, powered

Keystone correction range

Vertical ±40°, horizontal ±15° (vertical ±22° and horizontal ±15° with the ET-D75LE5/LE50, vertical ±28° and horizontal ±15° with the ET-D75LE6) When using only the KEYSTONE correction of the Geometric Adjustment function: Vertical ±40°, horizontal ±15°

Installation

Ceiling/floor, front/rear

Terminals - SDI IN

BNC × 1, 3G-SDI signal: SMPTE ST 424 compliant HD-SDI signal: SMPTE ST 292 compliant SD-SDI signal: SMPTE ST 259 compliant

Terminals - HDMI IN

HDMI 19-pin × 1, Deep Color, compatible with HDCP, 525i(480i), 625i(576i), 525p(480p), 625p(576p), 750(720)/60p, 750(720)50p, 1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p, 1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p, 1125(1080)/60p, 1125(1080)/50p, VGA (640 × 480) – WUXGA (1,920 × 1,200), dot clock: 25 MHz –162 MHz

Terminals - DVI-D IN

DVI-D 24-pin × 1, DVI 1.0 compliant, HDCP compatible, for single link only 525i(480i), 625i(576i), 525p(480p), 625p(576p), 750(720)/60p, 750(720)50p, 1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p, 1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p, 1125(1080)/60p, 1125(1080)/50p VGA (640 × 480) – WUXGA (1,920 × 1,200), dot clock: 25 MHz –162 MHz

Terminals - RGB 1 IN

BNC × 5

Terminals - R, G, B

R: 0.7 Vp-p, 75 ohms, G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms, B: 0.7 Vp-p, 75 ohms HD, VD/SYNC: TTL, high impedance, positive/negative automatic

Terminals - Y, PB, PR (Y, CB, CR)

Y: 1.0 Vp-p (including sync signal), PB/PR (CB/CR): 0.7 Vp-p, 75 ohms

Terminals - S-Video signal

Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms

Terminals - RGB 2 IN

D-sub HD 15-pin (female) × 1

Terminals - VIDEO IN

BNC × 1, 1.0 Vp-p, 75 ohms

Terminals - SERIAL IN

D-sub 9-pin (female) × 1 for external control (RS-232C compliant)

Terminals - SERIAL OUT

D-sub 9-pin (male) × 1 for link control (RS-232C compliant)

Terminals - REMOTE 1 IN

M3 jack × 1 for wired remote control

Terminals - REMOTE 1 OUT

M3 jack × 1 for link control

Terminals - REMOTE 2 IN

D-sub 9-pin × 1 for external control (parallel)

Terminals - LAN

RJ-45 × 1 for network connection, 100Base-TX/10Base-T, compliant with PJLink (class 1)

Power cord length

3.0 m (9 ft 10 in)

Cabinet materials

Molded plastic

Dimensions (W × H × D)

530 × 200 × 548.5 mm (20-7/8 × 7-7/8 × 21-19/32 inches) (without lens)

Weight

24 kg (52.9 lbs) (without lens)

Operation noise

43 dB (normal mode), 37 dB (eco mode)

Operating temperature

0°– 45°C (32°–113°F

Operating humidity

10%–80% (no condensation)

Remote control unit - Power supply

3 V DC (AA/R6 type battery × 2)

Remote control unit - Operation range

Approx. 30 m (98 5 in) when operated from directly in front of the signal receptor

Remote control unit - Dimensions (W × H × D)

51 × 176 × 28 mm (2 × 6-15/16 × 1-3/32 inches)

Remote control unit - Weight

Approx. 134 g (4.7 oz) (including batteries)

Supplied accessories

Power cord (×1) (x2 for PT-DZ10KE) Wireless/wired remote control unit (× 1) Batteries for remote control (AA/R6 type × 2) Softwar Lens drop-prevention screw (× 1) e CD-ROM (Logo Transfer Software, Multi Projector Monitoring & Control Software) (× 1)

Optional accessories

Zoom lens (0.9 –1.1:1) - ET-D75LE6, Zoom lens (1.3 – 1.7:1) - ET-D75LE10, Zoom lens (1.7– 2.4:1) - ET-D75LE20, Zoom lens (2.4 – 4.7:1) - ET-D75LE30, Zoom lens (4.6 – 7.4:1) - ET-D75LE40, Zoom lens (7.3 – 13.8:1) - ET-D75LE8, Fixed-focus lens (0.7:1) - ET-D75LE50, Lens motor cover - ET-D75MC1, Ceiling mount bracket - ET-PKD120H (for high ceilings), ET-PKD120S (for low ceilings), Attachment for ceiling mount bracket - ET-PAD310, Frame - PFD310, Smoke cut filter - ET-SFD320, Replacement smoke cut filter - ET-SFR320, Replacement lamp unit - ET-LAD310A (one bulb), ET-LAD310AW (a set of two bulbs), Replacement lamp unit for portrait mode - ET-LAD320P (one bulb), ET-LAD320PW (a set of two bulbs), Replacement filter unit - ET-EMF320